Learning Opportunity
📚Introducing Fluna Academy! Gain practical knowledge to boost your agri-exports.Access Now
November 12, 2026
Bean count and the cut test: reading a Ghanaian cocoa grading sheet before you bid

Bean count and the cut test: reading a Ghanaian cocoa grading sheet before you bid

By Sandra Nansbuga

cocoa grading ghanacocoa bean countcut testghana cocoacocoa quality standards

Bean count and the cut test: reading a Ghanaian cocoa grading sheet before you bid

Bean count is the number of whole beans that weigh 100 g, and the cut test is the share of a 300 bean sample showing mould, slaty colour, insect damage or germination. Both appear on a Ghanaian grading sheet, and the cut test decides whether a lot meets the grade one or grade two defect ceilings.

What does bean count mean on a Ghana cocoa grading sheet?

The national implementation guide to the Ghana Standard GS ARS 1000 Part 2 defines bean count as the total number of whole beans per 100 g, measured as Annex D sets out. The count comes from a test sample of at least 600 g drawn with a flat bottomed shovel, after sieving and removing cocoa related matter, flat beans and foreign matter.

Clause 6.4 turns the figure into a size band: premium at 80 to 90 beans per 100 g, standard at 91 to 105, medium at 106 to 110, small at 111 to 120, and very small above 120. Main crop beans carry a lower count and light crop beans a higher one, the guide notes.

How is the cut test measured?

Annex E requires 300 whole beans from the same test sample, cut lengthwise through the middle to expose the largest cotyledon surface and examined in full daylight. Each defective bean is counted once, under whichever defect comes first in the grading list, each class reported as a percentage of the 300.

A slaty bean shows slaty colour on at least half of the exposed cotyledon surface, and mould must not be confused with white spot, a concentration of theobromine or cocoa fat.

Attribute Grade 1 Grade 2
Mouldy, max by count 3 per cent 4 per cent
Slaty, max by count 3 per cent 8 per cent
Insect damaged and/or germinated, max by count 3 per cent 6 per cent

The Ghana Cocoa Board specification page publishes the same ceilings, and the third column is a combined total: grade 2 allows 6 per cent across insect damaged and germinated beans, not 6 per cent of each.

The Cocoa Post, in its 2020 article on the bean count parameter, notes that a lower bean count points to higher fat, though moisture and shell content also contribute.

Which figures should a buyer see before agreeing a price?

Table 1 of the guide carries mass based limits. Moisture is capped at 8 per cent by mass, cocoa related matter at 3.5 per cent of the mass of the reference sample, flat beans at 1.5 per cent, foreign matter at 0.75 per cent and debris at 1.5 per cent.

Direction matters. A 3 per cent cut test ceiling counts beans, while a 1.5 per cent flat bean ceiling measures sample mass, so a figure without its basis cannot be checked against a contract.

Where the 1.5 per cent flat bean standard cannot be met, particularly in the light crop season, the guide asks buyer and supplier to agree what will be delivered. Settle that before the price.

What happens when a lot misses the grade?

Fermented beans above the grade 2 limits are substandard and marked SS. Beans above the international limits in Table 3 may not be exported unless a buyer requests that category: good fermented allows 5 per cent slaty and 5 per cent mouldy and/or insect damaged, fair fermented 10 per cent on each.

A grading sheet describes one lot. Licence conditions and route economics are separate: see Fluna's note on Uganda's coffee export licence bond and its Ghana to India cashew lane guide.

FAQ

Q: Is a lower bean count better?
A: Lower means larger. The guide's premium band is 80 to 90 beans per 100 g and its very small band is above 120.

Q: How many beans are cut in the cut test?
A: 300 whole beans, selected irrespective of size, shape and condition, cut lengthwise, each defect class a percentage of those 300.

Q: Does grade 1 allow any mould?
A: Yes, up to 3 per cent by count. Grade 1 ceilings are 3 per cent mouldy, 3 per cent slaty and 3 per cent insect damaged and/or germinated.

Sources: Ghana cocoa | national implementation guide | The Cocoa Post